Search

Categories

Service
Hotline
86-574-63653672
QQ:
Service time:
8:00 - 18:30

Follow us - 

[ Scan QR code ]
 https://m.cnbxj.cn

CONTACT US

 

ADD:No. 10-12,huancheng Nan road,
Eastern Guanhaiwei Industrial area,Cixi City,Ningbo

SALES DEPT:86-574-63653672
TEL:86-574-63667178
FAX:86-574-63667433
E-mail: 
bxjreflector@cnbxj.cn

 

 

© Copyright 2018 cnbxj.cn Inc. All rights reserved.   
浙ICP备08108322号 Powered by www.300.cn

NEWS CENTER

 

Company news
Industry news

SERVICE

 

Messages

 

NEWS CENTER

>
>
Application of road stud reflector products in road

Application of road stud reflector products in road

Page view

Function of road stud reflector products.On a road to which subsection applies, the reflector or other component of a road marker, sign or other device that is installed to meet the requirements of this subsection cannot be considered to have been replaced or attached if:(a) the use of that component of the road marking, sign or other device by that road marking, sign or other device had been discontinued or was discontinued; or(b) the use that that component had been was discontinued or was discontinued but was reinstated.Division 2—Road marking4L Compliance with specified lighting standards(1) A road marking, sign or other device must comply with the requirements of the requirements specified in the standards.(2) The requirements may be specified, by reference to a particular colour, as being requirements of the requirements.


What are the characteristics of road stud reflector products?They are designed to reflect light to the outside so that it looks like the road the bicyclist is riding on. They are reflective of all road surface types. However, they do not illuminate the road surface. They make up the roadway only if a driver approaches the roadway from the right side but never passes below the street on the left side since the road may be wide enough for the bicyclist to be safely crossing without stopping.Where are the studs that are installed during install of street trees?Road stud reflectors use two sets of reflective material, called "bamboo" and "plastic" to reflect light to the road surface. "Bamboo" material absorbs as much as 99.5% of the light, while the plastic uses about 1/3 of the energy. The metal "plate" that holds the reflective material is either metal or rubber.
Principle of road stud reflector products.(a) Any vehicle or load shall be so constructed and disposed that the front and the rear of the vehicle or load shall always be visible to the operator of vehicular traffic in whole or in part at the rear.(b) The driver of every single-engined vehicle in this State shall cause the top of such vehicle to be at least two feet (2') above the ground when in motion and shall cause the rear of such vehicle to be at least two feet (2') above the ground when stationary.(c) Any vehicle or load shall be so constructed and disposed that the front and the rear of the vehicle or load shall have the same apparent height when in motion as a standard four-lane highway.
Installation and maintenance of road stud reflector products.(a) Maintenance of road studs. The department shall maintain road stud reflectors. Upon installation of studs, the stud shall be inspected for proper placement to insure that the stud is set at the desired position. If the studs are set at a position which is too low to meet minimum visibility requirements, the department may erect road stud reflectors in such other position so as to meet minimum visibility requirements. However, when the studs are placed in positions that are too high, damage to trees and shrubs or other objects along the roadway may prevent the lighting of the road which may impair compliance with lighting requirements. The department shall provide road stud reflectors products at reasonable cost and shall provide a method for a person who desires reflectors to request such reflectors free of charge, but in no event shall road stud reflectors be provided free of charge.

Company news
Industry news