At this stage, with the popularity of electric bicycles, the workload of vehicle supporting good price and quality bicycle led light manufacturers is also increasing. In order to expand production and increase output, the subsequent process improvement and upgrading is imperative. We note that there are still many safety warning lights, turn signals and brake lights, which are still produced and processed by the original assembly screw process, which not only consumes a lot of time, The workload has also been increased in the inspection of the qualified rate of the sealing test of electric bicycle led light products. After contacting some electric bicycle led light manufacturers, we should popularize the advanced process of ultrasonic welding of good price and quality bicycle led light from China manufacturer housing and lampshade. The following comparison can be made:
1. First fix the good price and quality bicycle led light from China manufacturer to the front of the electric vehicle, either below the basket or above the fender.
2. Pull the lead of the spotlight to the position of the headlights and fix the lead.
3. Use a screwdriver to open the panel of the good price and quality bicycle led light from China manufacturer, find the two leads of the headlights, use scissors at a random position of the leads, peel off a little skin, and leak out the copper wire inside.
4. Peel out the copper wire at the end of the good price and quality bicycle led light from China manufacturer and connect it to the lead of the headlamp (that is, the peeling position). Put the line in place and reinstall the cover plate. Turn on the power supply of the headlamp, and the spotlight and headlamp will light up at the same time.
When the good price and quality bicycle led light from China manufacturer combines the bulb, lamp shell, lamp holder and lampshade, the next step is to carry out sealing packaging. The screw not only does not have the same time cycle as ultrasonic welding, but also needs sealant pad, which expands the cost of production. The principle of ultrasonic welding plastic shell is to convert electric energy into mechanical energy, and the transducer converts kinetic energy into heat of plastic contact surface through high-frequency shaking, It takes only 2-3s to weld the two plastic shells together without any flux
We can clearly observe that the good price and quality bicycle led light from China manufacturer welded by ultrasonic wave not only ensures the tightness, but also won't fog. There's no need to be afraid that the good price and quality bicycle led light from China manufacturer doesn't light up in rainy days